Trombetta S500-A6 Electronic Control Module
S500-A6 Electronic Control Module
Trombetta's S500-A6 electronic control is a special module designed to enhance solenoid performance by increasing force capability and reducing operating temperature. Electronic controls for solenoids regulate the magnitude of electrical drive applied to the coil during the pull-in and/or hold operation of the solenoid to optimize performance of the solenoid.
Some applications require a high force capacity in a relatively small package. In order to achieve this solution, these solenoids contain a "high" current pull-in coil and a "low" current, continuous duty hold-in coil. Once the solenoid has pulled-in it is necessary to disconnect the high current pull-in, winding from the system and leave only the low current hold coil energized to prevent coil burnouts.
The S500-A6 Module allows you to incorporate dual winding solenoids into your applications. The module accepts your 2 wire switched input, and applies this input simultaneously to both the solenoid pull-in and hold windings. After the actuation time the module timer/relay removes the power from the pull-in coil and and leaves only the hold-in coil energized.
The S500-A6 may be used in 12 volt and 24 volt applications. In a 12 volt application, the max load current is 80 and the max power load is 1000 watts. An external contactor must be used for controlling the load on 24V pull-in coils. This model handles a 10-32 volt input range, and has an actuation time of 0.4 to 0.6 seconds; 1 cycle per second maximum cycle rate; reverse polarity protection.
Trombetta's S500-A6 is a replacement module for the following relay modules:
Genie 89997
Bosch 1641
Caterpillar 254-5463
Please Note: If you have an old Trombetta Solenoid part #P613-A41V12 that no longer works but you would like to continue using the S500-A6, we suggest getting the P613-1K2V12 as a replacement.
If instead you would like to upgrade to our newer solid state control module, the S500-A60, we include the S500-A60 control module in a kit with the P613-A41V12 solenoid and the attached cable.
Literature:
- Electronic Controls Brochure
- Sales Bulletin: S500-A6
- Instruction Sheet: S500-A6
- Dimensions & Wiring Diagrams: S500-A6
MurCal is an Authorized Distributor of Trombetta products.
MurCal provides application and product support, before and after the sale. Our in-house technical sales representatives have been trained by Trombetta and have the knowledge necessary to answer your questions. When you make an important purchase decision, be sure to consider the company that provides Trombetta's factory authorized sales and service.
For California customers: Prop 65 WARNING: This product may have been manufactured with or uses components that can expose you to chemicals which are known to the State of California to cause cancer. For more information go to www.p65warnings.ca.gov.